Bruno SRE-2700 Installation Manual Page 1

1780 EXECUTIVE DR., P.O. BOX 84, OCONOMOWOC, WI 53066 USATELEPHONE:(262) 567-4990FAX: (262) 953-55011-800-882-8183DEALER:Technical Service email: serv

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200710INSTALLATION

11SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®INSTALLATION

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200712Distinguishing left- and right-hand charge bumper brackets LEFT-HAND INSTALLAT

13SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®IMPORTANT NOTE!Under no circumstances should a rail section be cut shorter than 1

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200714INSTALLATION1. BE SURE TO WEAR PROTECTIVE GLOVES AND EYEWEAR. During the cutting

15SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®INSTALLATION1. Place rail clamps on the stairs in the following pattern (LONGER

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-2007164. Place the upper section of the rail in the clamps placed in Step 1. When the

17SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®1-1/4”IMPORTANT NOTESThe rail must rest approximately 1-1/4 inches (32 mm) above

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-20071811. Tighten the clamp hardware enough to render the upper rail immobile. Do not

19SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®Bruno ships this stairway elevator with fasteners appropriate for WOODEN STAIR TR

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-20072NOTE: Please locate the metal templates for drilling the mounting holes for the l

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-2007201. Once the clamps are in place, and secure, and after verifying that the rail b

21SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®INSTALLATIONMounting the carriage, upper bumper and upper end cap1. Lift and til

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200722INSTALLATIONAdjusting the carriage angle1. Using the remote, verify that the ca

23SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®Note on carriage plate:Longer M14 bolts must be used to install footrestLonger M

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200724Mounting the seat assemblyfront cover mount1. Slide the seat post assembly betwe

25SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®5. Mount the seat mount cover using the pre-attached Velcro® strips.6. Mount th

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200726Mounting the nal limit ramp kitThe nal limit ramp kit is a safety feature which

27SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®ELECTRICALINFRARED CALL/SEND TRANSMITTERThe call/send system on the Bruno SRE-200

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200728• Install the key-controlled call/send transmitters as shown below. • The key s

29SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®• Train the customer to use the stairway elevator correctly and safely.• Have

3SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.® TABLE OF CONTENTSImportant Notes ...2Regul

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200730CIRCUIT BOARD DIAGNOSTICSThe circuit board provided on the SRE-2000C is equipped

31SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®Changing the PCB Diagnostic Mode1. Turn the circuit breaker on the carriage to `O

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200732ELECTRICALLEARNING THE INFRARED TRANSMITTER(not necessary when installing unit fo

33SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®ELECTRICALLEARNING THE INFRARED TRANSMITTER(not necessary when installing unit fo

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200734ELECTRICALMounting the battery charger1. Position the charger in a suitable per

35SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®ELECTRICALIf the charger is subject to a power line surge, the AC input fuse may

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200736Apply thin layer of white lithium grease to gear rack only.LUBRICATION1. Now tha

37SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®1. Before securing, all clamps and with the seat in the central riding position

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200738As shipped from the factory, the Electra-RideTM Elite is set up for left-side ins

39SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®12. Insert the shorter bolts ON THE LEFT, and the longer (M14) bolts ON THE RIGH

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-20074REGULATORY INFORMATIONMaterial safety data sheets (MSDS) on materi-als used on thi

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-2007401. Unscrew the (2) black screw bumpers.2. Remove the seat frame cover.3. Unpl

41SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®The speed adjustment potentiometer is on the carriage (see left).To adjust:1. Lo

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200742MAINTENANCEIf the elevator will remain unused for an extended period of time, tur

43SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®MAINTENANCEYEARLY MAINTENANCE OPERATIONS• Clean rails, racks and wheels. Regreas

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200744If the overspeed switch trips, reset two levers: (1) the overspeed lever, and (2)

45SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®WIRING SCHEMATIC

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200746UNIT OPERATES ERRATICALLY OR INTERMITTENTLY WITH REMOTE CALL/SEND• Check fuse, re

47SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®• This is correct lift operation, a safety switch in the seat swivel prevents th

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200748CLAMP ASSEMBLIES

49SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®EXPLODED VIEWS/BILLS OF MATERIALS

5SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®STAIRWAY ELEVATOR SPECIFICATIONSWeight Capacity: 400 lbs. (181 kg)Variable Speed:

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200750EXPLODED VIEWS/BILLS OF MATERIALS

51SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®EXPLODED VIEWS/BILLS OF MATERIALS

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-2007521517CLEAN AND DEGREASE PARTS,OF MFHS-06001 (2) & MFHS-10001432193930215 82967

53SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®15for your independenceSHEET 1 OF 1RIGHT MAIN DRIVE ASSEMBLY W/OVERSPEEDSRE-20121

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-200754EXPLODED VIEWS/BILLS OF MATERIALS

FIVE YEAR MAJOR COMPONENTS WARRANTYTWO YEAR LIMITED WARRANTYfor Bruno StairliftsBruno Independent Living Aids, Inc. (“Bruno”), warrants to the origina

Bruno Independent Living Aids, Inc®1780 Executive Drive, P.O. Box 84, Oconomowoc, WI 53066262-567-4990 • FAX: 262-953-5501 • www.bruno.com©2006 Br

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-20076Thank you for purchasing a Bruno SRE-2000C ELECTRA-RIDE™ ELITE STAIRWAY ELEVATOR.

7SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®CARTON CONTENTSCHECK TO BE SURE THAT YOU HAVE ALL OF THE COMPONENTS BEFORE BEGINNI

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®SRE-2000C 11-14-20078TOOLS NEEDED FOR INSTALLATIONBE SURE YOU HAVE ALL NECESSARY PARTS AND TOOLS BEFORE

9SRE-2000C 11-14-2007©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®INSTALLATION1. Determine whether the stairway elevator will be installed on the r