Bruno SRE-2700 Installation Manual download pdf (Page 37)

SRE-2000C 11-14-2007

1. Before securing, all clamps and with the seat in

the central riding position, use the rocker switch

to run carriage/seat assembly completely down

and up the rail.

2. Check the seat-to-wall clearance.

A clearance of 1/2" to 1" (13-25 mm) is acceptable.

3. Repeat the run with the seat in the folded posi-

tion. If necessary, adjust the rail placement by

sliding it closer to, or further from the wall.

4. Make a total of 5 or 6 trial runs to be sure all

components function correctly, and that proper

seat-to-wall clearance is maintained over the

entire length of travel.

5. Install and tighten the screws in the remaining

foot clamps, starting at the bottom and working

toward to top.

NOTE: On each clamp, tighten the back

foot rst!

6. Check tightness of all screws/bolts.

7. Run the carriage/seat assembly up and down

the rail to recheck the seat-to-wall clearance,

and to verify correct operation of all elevator

components.

8. Verify proper operation of the power supply,

call/send transmitters, on/off switch, footrest,

safety switches, and carriage limit switches.

9. Adjust the seat height, if necessary, to maxi-

mize the customer's comfort (see ADJUST-

MENTS).

10. Inform the customer of the location of the Opera-

tor's Manual. Encourage him/her to become famil-

iar with the contents of the Operator’s Manual.

11. Train the customer to use the stairway elevator

correctly and safely.

Remind him/her to always buckle the positioning

belt when on board the stairway elevator.

Be sure to have him/her operate the unit while

you are there to answer questions and address

concerns.

Testing elevator operation

Important to Know

Direction of travel of

the seat/carriage

corresponds to the

side of the rocker

switch depressed.

A slight delay will

occur between the time

the rocker switch is

depressed and the start

of carriage movement.

This is normal and is a

function of the soft start

feature of the controller.

The unit should travel

noticeably faster going

up than down.

GRADE 10.9 (Metric)

(Roughly equivalent to US

Grade 8)

M8 Grade 10.9 25 lb.-ft

M10 Grade 10.9 47 lb.-ft

M12 Grade 10.9 83 lb.-ft

M14 Grade 10.9 133 lb.-ft

Torque Specications

TESTING

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Comments to this Manuals

No comments

Bruno SRE-2700 Installation Manual Page 37

Comments to this Manuals